Avaya Nortel Communication Server 1000 Manual page 468

468 Voice Gateway Media Card maintenance
Table 136
Voice Gateway commands
Command
vgwPLLog
vgwShow
vgwShowALL
vgwShow
The vgwShow command can be issued with no parameters or with the IP
address of an IP Phone using one of the Voice Channels.
vgwShow "x.x.x.x"
where
"x.x.x.x" is the IP address of one of the IP Phones.
The IP address "x.x.x.x" is the PUBLIC IP address of the IP Phone. If there
are multiple IP Phones using the same public IP address, the output is
similar to the example shown in
output" (page
Figure 104
vgwShow command sample output
The number of IP Phones that use that public IP address is printed (2 in this
example), but only one of the IP Phones is displayed. To see the other IP
Phone, determine the Public IP address and Public Media Port using the
Copyright © 2003–2008, Nortel Networks
.
Description
Toggles gateway packet loss logging on and off.
This command does not appear on the MC 32S
card.
Displays information about the active (non-idle and
equipped) gateway channels.
Entering this command with the IP address of
an IP Phone at the Command Line Interface of
any node Voice Gateway Media Card displays
the identification of the card that has a gateway
channel in use by the IP Phone. This information is
useful when there is a need to identify from which
card to collect gateway statistics (for example,
packet loss).
Displays information about all gateway channels.
Figure 104 "vgwShow command sample
468).
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Signaling
Server