Avaya Nortel Communication Server 1000 Manual page 475

IPL> command
disiTPS
disiVGW
enaAll
enlServices
enaTPS
enaVGW
forcedisServices
loadBalance
IP Phone Loss Plan (UK) commands
These commands set and adjust the gains for the UK (or other places where
loss plan adjustment of IP Phones is needed).
For more information about the UK Loss Plan, see
297).
For more information about IP Phone Loss Plan (UK) commands, see
Software Input Output Reference—Maintenance (NN43001-711).
Table 140
IP Phone Loss Plan commands
IPL> command
UKLossPlanSet
Copyright © 2003–2008, Nortel Networks
.
Description
Gracefully disables the LTPS service on the
Voice Gateway Media Card. Prevents new
IP Phones registering on the card, and all
registered IP Phones are redirected to another
card when idle.
Gracefully disables voice gateway service.
Enables both the LTPS and voice gateway
service on the Voice Gateway Media Card.
Enables the LTPS on the Signaling Server.
Enables all the Voice Gateway Media Cards
or Signaling Servers to accept registrations of
resources.
Enables the LTPS service.
Enables the voice gateway service.
Forces all registered resources on the Voice
Gateway Media Card or Signaling Server to
re-register with the other Voice Gateway Media
Cards or Signaling Servers in the node. This
command will interrupt established calls.
Causes the Voice Gateway Media Card or
Signaling Server to attempt to balance the
registration load between this card/server and
the rest of the node components.
Description
Increases the Tx level of the IP Phone to match
the requirement for the UK.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
IP Line CLI commands 475
Signaling
Server
X
X
X
X
X
X
"United Kingdom" (page
Signaling
Server
X