Procedure 26 Configuring Dsp Profile Data - Avaya Nortel Communication Server 1000 Manual

5
6
Configure Voice Gateway Profile data
Follow the steps in
285)
Procedure 26
Configuring DSP Profile data
Step
1
Copyright © 2003–2008, Nortel Networks
.
Information Base (MIB) and trap generation, and administrator
community strings for access to the MIB views.
• System Management Read
• System Management Write
• Trap community
• Administrator Group
The SNMP community strings control access to the IP Telephony
node. Element Manager uses the community strings to refresh the
Voice Gateway Media Card status and to control the transmitting and
retrieving of configuration data files for database synchronization.
In the Trap Destinations section, enter the IP address of the trap
destination. SNMP traps are sent to the IP address entered. A
maximum of 8 IP addresses can be configured.
Click Save.
The parameters are automatically synchronized to the Call Server,
Signaling Server, Voice Gateway Media Cards, and Media Gateway
Controller.
After the parameters are synchronized, the associated host route
entries are added to the routing table automatically. If a trap
destination is removed, the corresponding routing table entry is
removed as a result.
Procedure 26 "Configuring DSP Profile data" (page
to configure the Voice Gateway Profile data.
Action
In the Edit window, click VGW and IP Phone codec profile.
The VGW and IP phone codec profile information expands. See
Figure 64 "VGW and IP phone codec profile window" (page
The VGW and IP phone codec profile area includes VGW
information and a list of codecs.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Configure IP Line data using Element Manager 285
—End—
286).