Transfer Node Configuration From Element Manager To The Voice Gateway Media Cards - Avaya Nortel Communication Server 1000 Manual

Transfer node configuration from Element Manager to the Voice Gateway Media Cards 301
Transfer node configuration from Element Manager to the Voice
Gateway Media Cards
Before beginning the node configuration transfer, ensure the following:
•
•
•
The IP Telephony node and card properties are configured using Element
Manager. The configuration data is saved to the Call Server and then
transferred to the Voice Gateway Media Cards.
Saving the configuration
The configuration data is saved when the Save and Transfer button in the
Edit window is clicked. The files are saved to the Call Server. After the
data is saved, the configuration must be transferred to the Voice Gateway
Media Card. When Transfer/Status in the Edit window is clicked, Element
Manager instructs each card where to retrieve the files using FTP. The Voice
Gateway Media Card then retrieves the CONFIG.INI and BOOTP.TAB files.
Transferring the configuration - main node
For a Signaling Server node, the process to transfer the node configuration
to the cards consists of the following steps:
1. Transmit the node properties. See
2. Configure the Follower card. See
Copyright © 2003–2008, Nortel Networks
.
version on the Voice Gateway Media Card and upgrade the
software if necessary. See
Media Card software and IP Phone firmware" (page
The Voice Gateway Media Cards and cables have been installed.
The ELAN and TLAN network interfaces of all cards have access to
the IP network.
To enable access to Element Manager through a Web browser, a
network PC must be able to access the node Signaling Server, either
directly or remotely.
properties to Leader" (page
Follower cards" (page
The following sequence of steps are applicable only to nodes that
do not use the Signaling Server as the Leader; that is, a second (or
subsequent) node is being configured on the system – not the main
node. The Signaling Server must be properly configured to use Element
Manager, so that the steps of setting and rebooting the Leader are not
needed. The Signaling Server requires a reboot only if the Signaling
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
"Upgrade the Voice Gateway
—End—
Procedure 34 "Transmitting node
304).
Procedure 35 "Configuring the
306).
307).