Avaya Nortel Communication Server 1000 Manual page 447

Table 125
LD 32 Maintenance commands for the Voice Gateway Media Card
Description
Command
Disable the specified card,
DISC l s c
where: l = loop, s = shelf, c = card.
Disable the Voice Gateway Media Card before transmitting card properties
from the TM IP Line application. The card reset button is available only in the
TM IP Line application when the card is disabled.
When the Voice Gateway Media Card is disabled in LD 32, it does not disable
the active Leader or backup Leader functions.
Disable the specified card when idle,
DISI l s c
where: l = loop, s = shelf, c = card
This temporarily prevents the IP Telephony node from seizing the port from
incoming calls.
Use the DISI command to disable the Voice Gateway Media Card instead of
the DISC command. The disabled state of the Voice Gateway Media Card is
indicated by the NPR0011 message.
Disable the specified unit, where: l = loop, s = shelf, c = card, u = unit
DISU l s c u
Counts and prints the number of IP Phones registered for the specified card.
ECNT CARD L S
C <customer>
•
•
Example:
ECNT CARD 81
<< Card 81 >>
Number of Registered Ethersets: 5
Number of Unregistered Ethersets: 27
Copyright © 2003–2008, Nortel Networks
.
IP Line and IP Phone maintenance and diagnostics 447
If the <customer> parameter is specified, the count is specific to that
customer. A card must be specified to enter a customer; otherwise, the
count is across all customers.
If no parameters are entered, the count is printed for all zones. A partial
TN can be entered for the card (L or L S) which then prints the count per
that parameter. A customer cannot be specified in this case.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008