Procedure 70 Replacing A Leader Voice Gateway Media Card - Avaya Nortel Communication Server 1000 Manual

496 Voice Gateway Media Card maintenance using Element Manager
16
17
18
Replace a Leader Voice Gateway Media Card
To replace a Leader Voice Gateway Media Card, follow the steps in
Procedure 70 "Replacing a Leader Voice Gateway Media Card" (page
Procedure 70
Replacing a Leader Voice Gateway Media Card
Step
1
2
3
4
5
6
Copyright © 2003–2008, Nortel Networks
.
Follow the steps in Procedure 37 "Upgrading the card loadware"
(page 311) to download the latest software to the Voice Gateway
Media Card.
Follow the steps in Procedure 38 "Rebooting the Voice Gateway
Media Card" (page 312)
Follow the steps in Procedure 40 "Upgrading the IP Phone firmware"
(page 314) to update the card firmware.
Action
Locate the faulty card by the TN, MAC address, and IP address.
Disable the faulty Voice Gateway Media Card in LD 32 with the DISI
command.
The system outputs "NPR0011" when the card has been completely
disabled by the DISI command.
Use the disiTPS command at the IPL> CLI to disable the LTPS on
the faulty Voice Gateway Media Card.
This forces all IP Phones registered on this card to re-register. If
there are sufficient resources, this can take up to several minutes.
If there are not sufficient resources, IP Phones can remain
unregistered indefinitely.
Use the isetShow command to monitor the status of the card and
the re-registration of the IP Phones.
The Voice Gateway Media Card is completely disabled when no IP
Phones are registered on the card.
Remove the faulty Voice Gateway Media Card from the system.
Install the replacement Voice Gateway Media Card into the card slot
in the system. To do this:
a. Pull the top and bottom locking devices away from the card
faceplate.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
to reboot the card and run the new software.
—End—
496).