Avaya Nortel Communication Server 1000 Manual page 497

7
8
9
10
11
12
13
Copyright © 2003–2008, Nortel Networks
.
b. Insert the Voice Gateway Media Card into the card guides and
gently push the card until it makes contact with the backplane
connector. Hook the locking devices.
When cards are installed, the red LED on the faceplate remains
lit until the card is configured and enabled in the software, at
which point in turns off. If the LED does not follow the pattern
described or operates in any other manner (such as continually
flashing or remaining weakly lit), replace the card.
Observe the faceplate maintenance display to see start-up
self-test results and status messages. A display of the type
F:xx indicates a failure. See
faceplate maintenance display codes" (page 438)
of the ITG-P 24-port line card display codes and to
"Media Card 32-port card faceplate maintenance display codes"
(page 439) for a listing of the Media Card display codes.
Go to the VxWorks shell. Configure the Voice Gateway Media Card
as a Leader using the ELAN network interface IP address and
subnet mask.
Restart the card.
The card obtains the ELAN network interface IP address and subnet
mask.
In the Element Manager navigator, click IP Network > Nodes:
Servers, Media Cards.
The Node Configuration window appears.
Click the Edit button associated with the node containing the card
to be replaced.
The Edit window appears.
Expand the Cards section by clicking the plus sign (+) to the left of
Cards.
Select the Voice Gateway Media Card from the list of cards in the
node.
Change the Embedded LAN (ELAN) MAC address field to the
MAC address of the replacement Voice Gateway Media Card. The
MAC address is the Ethernet address labeled on the faceplate of the
replacement Voice Gateway Media Card.
ELAN: xx:xx:xx:xx:xx:xx
TLAN: xx:xx:xx:xx:xx:xx
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Replace a Voice Gateway Media Card 497
Table 118 "ITG-P 24-port line card
for a listing
Table 119