Avaya Nortel Communication Server 1000 Manual page 145

The Call Server monitors the pbxLink.
The Call Server maintains a list of all known registered elements (Signaling
Servers and Voice Gateway Media Cards). When booted, a Call Server has
a 5-minute delay to enable these known elements to reestablish contact
with the Call Server.
If a known element fails to register with the Call Server, an ELAN0028
alarm is generated.
If an unknown Signaling Server or Voice Gateway Media Card registers with
the Call Server, an ELAN0029 alarm is generated.
Displaying pbxLink information
This section describes how to display pbxLink information using Element
Manager or CLI.
Element Manager
For CS 1000 systems, use the Element Manager IP Network >
Maintenance and Reports > Gen Cmds > Group - pbxLink > Command
- pbxLinkShow window to display the pbxLink information. See
"pbxLinkShow in Element Manager" (page
Figure 38
pbxLinkShow in Element Manager
CLI
For a CS 1000 system, use the LD 117 STAT SERV command at the
Command Line Interface (CLI) of the Call Server to display the pbxLink
information.
Copyright © 2003–2008, Nortel Networks
.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
pbxLink connection failure detection 145
145).
Figure 38