Avaya Nortel Communication Server 1000 Manual page 396

396 IP Line administration using Element Manager
20
21
22
23
24
25
26
27
28
29
30
31
Copyright © 2003–2008, Nortel Networks
.
If the card role is not a Follower as expected, Telnet to the card IPL>
or oam> CLI using Virtual Terminal, and enter the clearLeader
command to remove the clearLeader flag.
In the Element Manager navigator, click IP Network > Nodes:
Servers, Media Cards.
The Node Configuration window appears.
Click the Transfer/Status button for the node.
This action downloads the node information to the card.
In the Element Manager navigator, click IP Network > Maintenance
and Reports.
The Node Maintenance and Reports window appears.
Expand the node containing the new card that were added by
clicking the plus sign (+) to the left of the Node ID.
Click the Status button for each Voice Gateway Media Card that
was added.
The card status displays as "Enabled" or "Disabled". If the status
message of "Web3003: Destination IP address cannot be reached;
initial RPC failure" is displayed, then verify the network connection
and the proper configuration of the network equipment.
Verify that all the new Voice Gateway Media Cards in the node have
a signaling link to the Call Server.
In the Element Manager navigator, click IP Network > Maintenance
and Reports.
The Node Maintenance and Reports window appears.
Expand the node containing the Voice Gateway Media Card by
clicking the plus sign (+) to the left of the Node ID.
Click the GEN CMD button associated with the Voice Gateway
Media Card.
In the Group drop-down list, select pbxLink.
From the Command drop-down list, select pbxLinkShow.
Click RUN.
The output appears in the window below.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008