Avaya Nortel Communication Server 1000 Manual page 317

11
12
13
14
15
Copyright © 2003–2008, Nortel Networks
.
Upgrade the Voice Gateway Media Card software and IP Phone firmware 317
isetReset "xxx.xxx.xxx.xxx"
where
xxx.xxx.xxx.xxx is the IP Address of the selected IP Phone.
Monitor the display on the test IP Phone. As the IP Phone upgrades
the firmware, note the IP Address of the Signaling Server from which
the IP Phone is receiving its upgrade.
Press the Services key (key with globe with arrow pointing East and
West. The Services key enables access to the Telephone Options
list.
a. Press Select to select Telephone Options.
b. Use the Navigation keys to scroll to Set Info.
c. Press the Select soft key, then press the Navigation keys until
it displays FW Version. Select the appropriate firmware on the
Signaling Server.
Lift the handset of the IP Phone and make a call to verify the IP
Phone works.
Enable and schedule Firmware Download Maintenance Mode to
ensure that the Signaling Server utilize its processing power for the
firmware upgrade. For more information, see
Firmware Download for IP Phones" (page
Before proceeding, ensure the time on the Signaling Server is
configured correctly. Telnet to the Signaling Server and log in. At the
IPL> or oam> command line, enter the following:
umsUpgradeAll "hh:mma/p"
hh:mma/p specifies the time when the upgrade will occur, a
represents a.m., and p represents p.m. The time is in Standard
format.
For example, umsUpgradeAll "11:30a" or umsUpgradeAll "2:45p".
At the time specified, all the IP Phones registered to the Signaling
Server go out of service. This can take several minutes.
Upon completion of the firmware upgrade, the IP Phones are brought
back online as they complete their firmware upgrade.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
"Enhanced UNIStim
81).