Avaya Nortel Communication Server 1000 Manual page 522

522 Convert IP Trunk Cards to Voice Gateway Media Cards
14
15
Copyright © 2003–2008, Nortel Networks
.
Click Add next to the Cards section.
After all required fields for the card properties have been entered,
click Submit and Transfer.
This action saves the configuration changes to the Call Server and
transfers the changes to the Signaling Servers and Voice Gateway
Media Cards in the node.
The Transfer Progress window is displayed.
The BOOTP.1 and CONFIG.INI file are saved on the Call Server and
transferred to the Signaling Server Leader. The BOOTP table is
updated so that the converted cards can receive their IP addresses.
It might be necessary to press the Reset button on the faceplate
of the converted cards to trigger a new BOOTP request. Do not
continue with this procedure until all converted cards have received
their IP addresses.
Configure the new Voice Gateway TNs on the Call Server using one
of the following methods:
a. Use LD 14 from the Call Server CLI to configure the new Voice
Gateway TNs.
or
b. In the Element Manager navigator, click IP Network > Nodes:
Servers, Media Cards.
The Node Configuration window appears.
1. Expand the node by clicking the plus sign (+) to the left of
the Node ID.
2. Click the appropriate Voice Gateway Media Card.
3. Click VGW CHANNELS next to the appropriate Voice
Gateway Media Card.
The VGW Channels window appears.
4. if an Alert Box appears, log into the CLI of the Call Server.
In LD 22, enter 167 as a response to the TYPE prompt to
determine if Package 167 is enabled or restricted.
If it is restricted, obtain a new keycode to enable GPRI
Package 167.
In LD 73, enter DDB at the TYPE prompt.:
Press <CR> through the overlay, accepting all the defaults.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008