Equipment Considerations; Install The Hardware Components - Avaya Nortel Communication Server 1000 Manual

236 Installation and initial configuration of an IP Telephony node
•
•
•
•
•

Equipment considerations

This section lists the required and optional equipment that can be used to
install, configure, and maintain the Voice Gateway Media Cards and IP
Phone products.
Required equipment
The required equipment includes the following:
•
•
•
•
•
•
Optional equipment
The optional equipment includes the following:
•
•

Install the hardware components

The Media Card 32-port cards and the ITG-P 24-port line card use IP Line
software.
Copyright © 2003–2008, Nortel Networks
.
Procedure 14 "Installing the Media Card" (page 242)
Procedure 15 "Replacing the existing I/O Panel Filter Connector" (page
244)
Procedure 16 "Installing the NTMF94EA ELAN, TLAN, serial interface
cable" (page 248)
Procedure 17 "Installing the Shielded 50-pin to Serial/ELAN/TLAN
Adapter onto the Media Card" (page 250)
Procedure 18 "Configuring the ELAN network interface IP address for
the active ELNK" (page 252)
a PC to manage IP Line, with the Internet Explorer 6.0.2600 (or later)
to run Element Manager for CS 1000 systems
local TTY or terminal in a switch room (this is required for Leader
configuration)
two shielded CAT 5 Ethernet cables to connect the Voice Gateway
Media Card to an external switch (recommended) or hub equipment
10/100BaseT network interface (optional autosensing) to support TLAN
and 10BaseT ELAN network interface connections
10/100BaseT network interface (optional autosensing) in each location
where an IP Phone resides
serial cables
a server configured with Dynamic Host Configuration Protocol (DHCP);
for example, a Nortel NetID server
an external modem router to enable remote dial-up connection to the
ELAN subnet for technical support (Nortel RM356 modem router is
recommended)
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008