Procedure 82 Reconfiguring The Itg-P 24-Port Card Running Cs - Avaya Nortel Communication Server 1000 Manual

556 Appendix F Moving Voice Gateway Media Cards between systems
Use
Release 4.5 or later (Leader or Follower)" (page 559)
Media Card 32-port card.
Scenario 4
This scenario applies if the Media Card 32-port card:
•
•
•
Use
Release 4.0 or earlier (Leader or Follower)" (page 560)
Media Card 32-port card.
Use
Release 4.5 or later (Leader or Follower)" (page 556)
ITG-P 24-port card running CS 1000 Release 4.5 or later on a system
running CS 1000 Release 4.5 or later, where the card was a Leader or a
Follower in the original system.
Procedure 82
Reconfiguring the ITG-P 24-port card running CS 1000 Release 4.5 or later
(Leader or Follower)
Step
1
2
3
4
5
6
Copyright © 2003–2008, Nortel Networks
.
Procedure 84 "Reconfiguring the Media Cards running CS 1000
came from a system running CS 1000 Release 4.0 or earlier
was a Leader or a Follower in that system
is moving to a system running CS 1000 Release 4.5 or later
Procedure 85 "Reconfiguring the Media Cards running CS 1000
Procedure 82 "Reconfiguring the ITG-P 24-port card running CS 1000
Action
Press the reset button on the ITG-P 24-port card faceplate.
Access the card by the RS-232 Maintenance port.
At the prompt, to escape to BIOS VxWorks, enter
jkl
To change the ELAN IP address configuration, the IP Telephony
application Leader flag, and the IPL> prompt logon parameters in
NVRAM, enter
BIOS>nvramClear
The card becomes a Follower; the Leader flag is cleared and the IP
telephony parameters are reset to the default values.
To set the flag so the ELAN IP address configuration data is read
from the NVRAM instead of a BootP query, enter
BIOS>lnIsaIPMethodSet 2
At the prompt, enter
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
to reconfigure the
to reconfigure the
to reconfigure the