Procedure 80 Reconfiguring A Voice Gateway Media Card Running Cs - Avaya Nortel Communication Server 1000 Manual

5
6
Use
1000 Release 4.5 or later (Leader in original sy" (page 553)
a Voice Gateway Media Card running CS 1000 Release 4.5 on a system
running CS 1000 Release 4.5 or later, where the card was configured as
Leader in the original system.
Procedure 80
Reconfiguring a Voice Gateway Media Card running CS 1000 Release 4.5
or later (Leader in original system)
Step
1
2
3
4
5
6
7
Copyright © 2003–2008, Nortel Networks
.
Use Element Manager to select this Voice Gateway Media Card.
Click Transfer to Selected Elements to transfer config.ini and
bootp.tab files to the card.
See "Transmit node properties" (page
Procedure 80 "Reconfiguring a Voice Gateway Media Card running CS
Action
Press the reset button on the Voice Gateway Media Card faceplate.
Access the card by the EIA232 Maintenance port.
At the prompt, to escape to BIOS VxWorks shell, enter
jkl
At the prompt, enter
nvramClear
The nvramClear command clears the Leader flag and allows a
BootP request to be sent.
Enter
sysReboot
After this command executes, the card has the correct IP and
accounts information synchronized with the node. Try to access the
IPL>CLI using the user name and password from your Call Server.
Upgrade the Voice Gateway Media Card 8051XA Controller
firmware, if necessary.
Upgrade the Voice Gateway Media Card software, if necessary.
To upgrade the Voice Gateway Media Card software using Element
Manager, see Procedure 37 "Upgrading the card loadware" (page
311).
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
Reconfiguring the Voice Gateway Media Card 553
304).
—End—
to reconfigure