Avaya Nortel Communication Server 1000 Manual page 316

316 Configuration of IP Telephony nodes using Element Manager
5
6
7
8
9
10
Copyright © 2003–2008, Nortel Networks
.
Figure 75
Update Phone Firmware window
Click Browse to locate the firmware file on the PC.
Click Upload to upload the firmware to the Master TPS of the
selected IP Telephony node.
Check the status column to ensure the server placed the new file
in service.
Click Update to distribute the firmware.
Check the for the updated status message, which informs you that
the file is in service.
The IP Phones continue to run the old firmware until each IP Phone
re-registers with the Signaling Server containing the new IP Phone
firmware.
Repeat the preceding steps for all the card that have to be upgraded.
Commands are available from the IPL> or oam> command line to
upgrade a single IP Phone immediately, all IP Phones immediately,
or schedule all IP Phones to be upgraded at a later time. Before
doing this, verify that the Signaling Server has the correct IP Phone
firmware version.
Select an IP Phone for test purposes.
Telnet to the Signaling Server and then log into the IPL> or oam>
command line, and enter the following:
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008