Avaya Nortel Communication Server 1000 Manual page 340

340 IP Line administration
3
Copyright © 2003–2008, Nortel Networks
.
NodeID PwdEna Pwd
====== ======= ======== ======== ======= ===========
123 No
where
NodeID – the IP Phone Installer Password configuration applies
to all Voice Gateway Media Cards on the same TLAN that belong
to this Node ID.
PwdEna – by default the cards should be in disabled state
(PwdEna=No). The PwdEna setting specifies the enabled (Yes) or
disabled (No) state of the IP Phone Installer Password.
Pwd – this is the Administrator IP Phone Installer Password. In
the default state, the Administrator password is null (zero-length).
TmpPwd – this is the temporary IP Phone Installer Password. In
the default state, the temporary password is null.
Uses – the Uses parameter applies to the temporary IP Phone
Installer Password. In the default state, this setting is null. If the
card is not in the default state, the Uses parameter is a numeric
value from 0 –1000. This number specifies the remaining number
of uses for the temporary password. If zero is entered for the
Uses parameter when setting the temporary password, the Time
parameter is mandatory. When the Time parameter is in effect,
the password expiration is based on time instead of the number
of uses.
Timeout – the Timeout heading corresponds to the Time
parameter of the temporary IP Phone Installer Password. In the
default state, the Time is null. If the card is not in the default
state, this setting specifies the duration in hours in which the
temporary password is valid. The range is 0 – 240 hours (which
is a maximum of 10 days). The number specified under Timeout
indicates the remaining time to expire of the temporary password.
The Time parameter is optional if the Uses parameter is non-zero.
The Time parameter is mandatory if the Uses parameter is set
to zero.
If both the Uses and Time parameters are entered, the password
expires based on whichever happens first; that is, the number of
Uses is reduced to zero or the Time has expired. If both the Uses
and Time parameters are entered and are set to zero, it is the same
as not configuring the temporary password.
Configure the Administrator IP Phone Installer Password.
The nodePwdSet <"password"> command enables and
configures the administrator password. The <password> parameter
can be null, or 6 to 14 digits in length. The valid characters are 0 to
9, *, and #. This command can be entered at any time. The new
password entered simply overwrites the previous password.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
TmpPwd Uses
0d 0h 0m 0s
Timeout