Update Other Node Properties; Telnet To A Voice Gateway Media Card Using Virtual Terminal - Avaya Nortel Communication Server 1000 Manual

These changes affect the whole node. As a result, all the cards must be
restarted.
If the Management (ELAN) network interface IP address of the Leader has
changed, all the cards must be restarted. Even though this is a change
to a single card, this change affects all cards, as this IP address is used
to transmit properties to the node.
Follow the steps in
card" (page 409)
Procedure 56
Changing the IP address of the Leader card
Step
1
2
3
4

Update other node properties

Some basic Voice Gateway Media Card configuration must be performed
from the IP Network >Nodes: Servers, Media Cards > Edit window.
To update the node properties in the following sections:
•
•

Telnet to a Voice Gateway Media Card using Virtual Terminal

To access the CLI on a Voice Gateway Media Card using Virtual Terminal
from Element Manager, follow the steps in
Gateway Media Card using Telnet" (page
Copyright © 2003–2008, Nortel Networks
.
Telnet to a Voice Gateway Media Card using Virtual Terminal 409
Procedure 56 "Changing the IP address of the Leader
to restart all the Voice Gateway Media Cards.
Action
Telnet to the card.
Use the setLeader command to configure the new IP address.
The Leader uses this new IP address when it reboots.
Reboot the Leader using the cardReset command.
The Leader card reads the new IP address from NVRAM.
Restart all the other cards.
DSP Profile section – follow the steps in
DSP Profile data" (page 285)
QoS section – follow the steps in
(page 289)
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
—End—
Procedure 26 "Configuring
Procedure 27 "Configuring QoS"
Procedure 57 "Accessing a Voice
410).