Avaya Nortel Communication Server 1000 Manual page 457

Command
ping "host",
"numpackets"
electShow
itgCardShow
itgMemShow
ifShow
IPInfoShow
serialNumShow
firmwareVersionShow
numChannelsShow
swVersionShow
Copyright © 2003–2008, Nortel Networks
.
Description
This command does not appear on the MC 32S card.
Sends an ICMP ECHO_REQUEST packet to a
network host. The host matching the destination
address in the packets responds to the request. If
a response is not returned, the sender times out.
This command is useful to determine if other hosts
or Voice Gateway Media Cards are communicating
with the sender card. The "numpackets" parameter
specifies how many packets to send. If it is not
included, ping runs until it is stopped by Ctrl-C (also
exits the IPL> CLI).
Example:
IPL> ping "47.82.33.123", 10
Displays a list of cards in the node and information
about each card. This includes showing all registered
followers to a leader.
The output has two sections:
• cards currently registered
• cards that are in the BOOTP.TAB configuration
but not yet registered.
This command does not appear on the MC 32S card.
Displays Voice Gateway Media Card information.
Displays memory usage.
Displays detailed IP address information, including
MAC addresses.
Displays IP address information.
Displays card serial number.
This command displays the same Voice Gateway
Media Card serial number that is displayed in the LD
32 IDC command.
Displays firmware version number.
Displays number of available channels.
Displays software version.
Nortel Communication Server 1000
IP Line Fundamentals
NN43100-500 02.02 Standard
Release 5.5 4 February 2008
IP Line CLI commands 457
Signaling
Server
X
X
X
X
X
X
X
X