Rep 5.8 Takeaway And Cvt Sensor - Xerox WorkCentre 5790 Series Service Manual

4. Remove the duplex solenoid, Figure
3
Disconnect PJ205.
4
Disconnect the ground harness.
Figure 3 Duplex solenoid
Replacement
The screw that attaches the ground harness to the duplex solenoid is shorter than the other
screws. Do not use the incorrect screw.
Be careful when the self tapping screw is installed into a plastic component, refer to
1. The replacement is the reverse of the removal procedure. Make sure that the wiring is not
caught below the drive assembly.
2. Perform the DADH motor adjustment,
Xerox® WorkCentre® 5790 Family
3.
2
Remove the screw.
1
Disconnect the
link arm.
5
Release the duplex sole-
noid from the clips.
CAUTION
CAUTION
ADJ 5.1.

REP 5.8 Takeaway and CVT Sensor

Parts List on PL 5.20
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the DADH top cover assembly,
2. Remove the takeaway or CVT sensor,
2
Disconnect the correct PJ. Remove the
correct sensor.
GP 6.
May 2013
4-59
WARNING
GP 14. Disconnect the power cord from the
WARNING
REP 5.1.
Figure 1.
1
Remove the screw.
Figure 1 Takeaway and CVT sensors
REP 5.7, REP 5.8
Takeaway sensor.
CVT sensor.
Spring plate.
CVT idler roll
shaft.
Repairs/Adjustments