Danfoss VLT Series Programming Manual page 97

Local Control Panel (LCP) O...
1
Status
24 V 38 °C
2.1 kW
2
A
565 V
4
6
Quick
Status
B
Menu
7
10 C
On OK
15
Warn.
16
Alarm
17
Hand
D
O
On
18 19
Callout Description
number
1 AUX line voltage
2 Temperature power card
3 Actual UDC (current)
4 ISD power consumption
5 Actual UDC (voltage)
Illustration 4.2 Display Area when Connected to the SAB
B. Display menu keys
Menu keys are used to access menus for parameter set-up,
toggling through status display modes during normal
operation, and viewing fault log data.
Callout Key Function
number
6 Status Shows operational information.
7 Quick Menu Allows access to parameters.
8 Main Menu Allows access to parameters.
9 Alarm Log Shows the last 10 alarms.
Table 4.1 Display Menu Keys
MG36D102
Programming Guide
3
11.5 A
5
9
Main Alarm
Menu Log
8
11
12
13
Auto
Reset
On
14
20 21
Danfoss A/S © 01/2017 All rights reserved.
C. Navigation keys and indicator lights (LEDs)
Navigation keys are used to move the display cursor and
provide operation control in local operation. There are also
3 status LEDs in this area.
Callout Key Function
number
10 Back Reverts to the previous step or list in
the menu structure.
11 Cancel Cancels the last change or command
(unless the display mode is changed).
12 Info Gives a definition of the current
function.
13 Navigation The 4 keys enable navigation between
keys menu items.
14 OK Accesses parameter groups or enables
a selection.
Table 4.2 Navigation Keys
Callout LED Color
number
15 On Green
16 Warn. Yellow
17 Alarm Red
Table 4.3 Indicator Lights (LEDs)
D. Operation keys and reset
The operation keys are at the bottom of the LCP.
Callout Key Function
number
18 Hand On Enables the connected servo drive or
SAB to be controlled via the LCP. See
chapter 4.3.5 Hand On Mode for further
information.
Switching between Hand On mode and
Auto On mode is only possible in
certain states.
19 Off Puts the SAB into state Standby and
the servo drive to state Switch on
Disabled.
This only works in Hand On mode.
Off mode enables transition from Hand
On mode to Auto On mode.
Function
The On LED activates when the
servo drive or SAB it is
connected to receives power
from the mains, auxiliary
supply, or a DC bus terminal.
When a warning is issued, the
yellow Warn. LED activates and
text appears in the display area
identifying the problem.
A fault condition causes the
red Alarm LED to flash and an
alarm text is shown.
95
4 4