Parameter 15-30: Error Code (0X603F); Parameter 16-92: Warning Code (0X5Ffe); Parameter: Control Source (0X5020) - Danfoss VLT Series Programming Manual

Servo Drive Parameter Descr...

7.22.9 Parameter 15-30: Error Code (0x603F)

This object provides the error code of the last error that occurred in the servo drive.
Attribute
Index
LCP parameter number
Name
Object code
Data type
Sub-index
Access
PDO mapping
Value range
Default value
7 7 Table 7.256 0x603F: Error Code

7.22.10 Parameter 16-92: Warning Code (0x5FFE)

This object provides the warning code of the last warning that occurred in the servo drive.
Attribute
Index
LCP parameter number
Name
Object code
Data type
Sub-index
Access
PDO mapping
Value range
Default value
Table 7.257 0x5FFE: Warning Code

7.22.11 Parameter: Control Source (0x5020)

This object defines the current control source.
0 means that the device is controlled via fieldbus (remote/PLC).
1 means that the device is controlled via LCP.
Attribute
Index
LCP parameter number
Name
Object code
Data type
Sub-index
Access
PDO mapping
Value range
352
®
VLT Integrated Servo Drive ISD
Value
0x603F
15-30
Error code
Var
UNSIGNED16
0x00
Read only
Optional
See chapter 9.2.1 Troubleshooting
–
Value
0x5FFE
16-92
Warning code
Var
UNSIGNED16
0x00
Read only
Optional
See chapter 9.2.2 Error Codes
–
Value
0x5020
–
Control source
Var
UNSIGNED16
0x00
Read/write
Optional
0, 1
Danfoss A/S © 01/2017 All rights reserved.
®
510 System
MG36D102