Danfoss VLT Series Programming Manual page 319

Servo Drive Parameter Descr...
15 14
Parse digital CAM
switch data
MSB
Table 7.178 Digital CAM Switch Configuration
Bit Value
15 0
1
Table 7.179 Definition of Digital CAM Switch Configuration Bits
Digital CAM switch Description
parsing state
(sub-index 02)
0x0000 No error/valid
digital CAM
switch data
0x0001 File not found.
0x0004 Switches
currently active.
No parsing
possible.
0x0005 Out of digital
CAM switch
memory (digital
CAM switches
data is too
large).
0x000B Digital CAM
switch has no
switch.
0x000C Parameter is out
of range.
0x000D A mandatory
parameter is
missing.
0x000F A parameter in
the header has
wrong range.
0x0010 A mandatory
parameter is
missing in the
header.
0x7FFE An unknown
error occurred.
0x7FFF Parsing
Table 7.180 Digital CAM Switching State and Error Information
NOTICE
The counting of switches ID starts with 1.
MG36D102
Programming Guide
Definition
The servo drive automatically resets this bit to 0 if the parsing is started.
Triggers a new digital CAM switch parsing. This is needed if a new digital CAM switch data was
transferred over SDO, and if the data was transferred as a file.
Digital CAM switching parsing error information (sub-index 03)
Byte 0
Type of parameter:
See Table 7.133 in
chapter 7.14.4 Parame
ters: CAM Profile 1–8
(0x3810–0x3817).
Danfoss A/S © 01/2017 All rights reserved.
Reserved
Byte 1 Byte 2
Reserved
Reserved
Reserved
Reserved
Reserved
Switch ID
Reserved
Reserved
Reserved
Reserved
0
LSB
Byte 3
Reserved
317
7 7