Rtc Tamper And Alternate Function Configuration Register; (Rtc_Tafcr) - ST STM32F410 Reference Manual

Advanced arm-based 32-bit mcus
Table of Contents

Advertisement

RM0401
Bits 31:16 Reserved, must be kept at reset value
Bit 15 CALP: Increase frequency of RTC by 488.5 ppm
Refer to
Bit 14 CALW8: Use an 8-second calibration cycle period
Bit 13 CALW16: Use a 16-second calibration cycle period
Note: CALM[0] is stuck at '0' when CALW16='1'.
Bits 12:9 Reserved, must be kept at reset value
Bits 8:0 CALM[8:0]: Calibration minus
Note:
This register is write protected. The write access procedure is described in
write
protection.
21.6.17

RTC tamper and alternate function configuration register

(RTC_TAFCR)

Address offset: 0x40
Backup domain reset value: 0x0000 0000
System reset: not affected
31
30
29
28
Res.
Res.
Res.
Res.
15
14
13
12
TAMP
TAMP
TAMP
PUDIS
PRCH[1:0]
FLT[1:0]
rw
rw
rw
rw
0: No RTCCLK pulses are added.
1: One RTCCLK pulse is effectively inserted every 2
488.5 ppm).
This feature is intended to be used in conjunction with CALM, which lowers the frequency of
the calendar with a fine resolution. if the input frequency is 32768 Hz, the number of
RTCCLK pulses added during a 32-second window is calculated as follows: (512 * CALP) -
CALM.
Section 21.3.11: RTC smooth digital
When CALW8 is set to '1', the 8-second calibration cycle period is selected.
CALM[1:0] are stuck at "00" when CALW8='1'.
Refer to
Section 21.3.11: RTC smooth digital
When CALW16 is set to '1', the 16-second calibration cycle period is selected. This bit must
not be set to '1' if CALW8=1.
Refer to
Section 21.3.11: RTC smooth digital
The frequency of the calendar is reduced by masking CALM out of 2
seconds if the input frequency is 32768 Hz). This decreases the frequency of the calendar
with a resolution of 0.9537 ppm.
To increase the frequency of the calendar, this feature should be used in conjunction with
CALP.
See
Section 21.3.11: RTC smooth digital calibration on page
27
26
25
24
Res.
Res.
Res.
Res.
11
10
9
8
TAMP
FREQ[2:0]
rw
rw
rw
rw
calibration.
calibration.
calibration.
23
22
21
20
Res.
Res.
Res.
Res.
7
6
5
4
TAMP2
TAMPTS
Res.
Res.
TRG
rw
rw
RM0401 Rev 3
Real-time clock (RTC)
11
pulses (frequency increased by
20
RTCCLK pulses (32
495.
RTC register
19
18
ALARMOUT
Res.
TYPE
rw
3
2
TAMP2E
TAMPIE
TAMP1TRG TAMP1E
rw
rw
17
16
TSIN
TAMP1I
SEL
NSEL
rw
rw
1
0
rw
rw
517/771
523

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STM32F410 and is the answer not in the manual?

Table of Contents

Save PDF