Spanning-Tree Link-Type; Spanning-Tree Pathcost Method - Allied Telesis AT-8000S Cli Reference Manual

Allied Telesyn AT-8000S Switch
CLI Reference Guide
Example
The following example enables PortFast on Ethernet port 1/e15
Console(config)# interface ethernet 1/e15
Console(config-if)# spanning-tree portfast

spanning-tree link-type

The spanning-tree link-type Interface Configuration mode command overrides the default link-type setting
determined by the duplex mode of the port and enables Rapid Spanning Tree Protocol (RSTP) transitions to the
forwarding state. To return to the default configuration, use the no form of this command.
Syntax
spanning-tree link-type {point-to-point | shared}
no spanning-tree spanning-tree link-type
Parameters
•
point-to-point —Indicates that the port link type is point-to-point.
•
shared — Indicates that the port link type is shared.
Default Configuration
The device derives the port link type from the duplex mode. A full-duplex port is considered a point-to-point link
and a half-duplex port is considered a shared link.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables shared spanning-tree on Ethernet port 1/e5
Console(config)# interface ethernet 1/e15
Console(config-if)# spanning-tree link-type shared

spanning-tree pathcost method

The spanning-tree pathcost method Global Configuration mode command sets the default path cost method. To
return to the default configuration, use the no form of this command.
Syntax
spanning-tree pathcost method {long | short}
no spanning-tree pathcost method
.
.
Page 188