Ip Igmp Mroute-Proxy - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
-
IP IGMP MROUTE PROXY

ip igmp mroute-proxy

Overview Use this command to enable IGMP mroute proxy on this downstream interface and
associate it with the upstream proxy service interface.
Use the no variant of this command to remove the association with the
proxy-service interface.
Syntax ip igmp mroute-proxy <interface>
no ip igmp mroute-proxy
Mode Interface Configuration for a VLAN or Eth interface.
Usage This command applies to Eth interfaces and VLAN interfaces configured for IGMP
Proxy.
You must also enable the IGMP proxy service on the upstream interface, using the
ip igmp proxy-service
mroute proxy interfaces on the device with a single upstream proxy service
interface. This downstream mroute proxy interface listens for IGMP reports, and
forwards them to the upstream IGMP proxy service interface.
IGMP Proxy does not work with other multicast routing protocols, such as PIM-SM
or PIM-DM.
Example To configure vlan2 as the upstream proxy-service interface for the downstream
vlan3 interface, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip igmp proxy-service
Commands
C613-50186-01 Rev B
Parameter
<interface>
command. You can associate one or more downstream
configure terminal
interface vlan3
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The name of the interface.
ip igmp mroute-proxy vlan2
1558