Ip Igmp Querier-Timeout - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
-
IP IGMP QUERIER TIMEOUT

ip igmp querier-timeout

Overview Use this command to configure the timeout period before the device takes over as
the querier for the interface after the previous querier has stopped querying.
Use the no variant of this command to restore the default.
Syntax ip igmp querier-timeout <timeout>
no ip igmp querier-timeout
Default The default timeout interval is 255 seconds.
Mode Interface Configuration for a VLAN or Eth interface.
Usage This command applies to Eth and VLAN interfaces configured for IGMP.
The timeout value should not be less than the current active querier's general
query interval.
Example To configure the device to wait 130 seconds from the time it received the last query
before it takes over as the querier for vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ip igmp query-interval
Commands
show ip igmp interface
show running-config
C613-50186-01 Rev B
Parameter Description
<timeout>
IGMP querier timeout interval value in seconds, in the range 1-
65535.
configure terminal
interface vlan2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip igmp querier-timeout 130
1560