Ip Igmp Snooping Mrouter - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS

IP IGMP SNOOPING MROUTER

ip igmp snooping mrouter
Overview Use this command to statically configure the specified port as a multicast router
port for IGMP Snooping for an interface. This command applies to interfaces
configured for IGMP Snooping.
Use the no variant of this command to remove the static configuration of the port
as a multicast router port.
ip igmp snooping mrouter interface <port>
Syntax
no ip igmp snooping mrouter interface <port>
Mode Interface Configuration for a VLAN interface.
Example To configure port1.0.2 statically as a multicast router interface for vlan2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show ip igmp snooping mrouter
Commands
C613-50186-01 Rev B
Parameter Description
<port> The port may be a device port (e.g. port1.0.4), a static channel
group (e.g. sa3), or a dynamic (LACP) channel group (e.g. po4).
configure terminal
interface vlan2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip igmp snooping mrouter interface port1.0.2
1571