Ip Igmp Robustness-Variable - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
-
IP IGMP ROBUSTNESS VARIABLE

ip igmp robustness-variable

Overview Use this command to change the robustness variable value on an interface.
Use the no variant of this command to return to the default on an interface.
Syntax ip igmp robustness-variable <1-7>
no ip igmp robustness-variable
Default The default robustness variable value is 2.
Mode Interface Configuration for a VLAN or Eth interface.
Usage This command applies to interfaces configured for IGMP and IGMP Snooping.
Examples To set the robustness variable to 3 on vlan20, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show ip igmp interface
Commands
show running-config
C613-50186-01 Rev B
Parameter Description
<1-7>
The robustness variable value.
configure terminal
interface vlan20
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip igmp robustness-variable 3
1568