Ip Igmp Query-Max-Response-Time - Allied Telesis AR2050V Command Reference Manual

IGMP IGMP S C
AND NOOPING OMMANDS
- - -
IP IGMP QUERY MAX RESPONSE TIME

ip igmp query-max-response-time

Overview Use this command to configure the maximum response time advertised in IGMP
Queries.
Use the no variant of this command to restore the default.
NOTE
interval.
ip igmp query-max-response-time <response-time>
Syntax
no ip igmp query-max-response-time
Default The default IGMP query maximum response time is 10 seconds.
Mode Interface Configuration for a VLAN or Eth interface.
Usage This command applies to interfaces configured for IGMP.
Note that the IGMP query interval is automatically set to a greater value than the
IGMP query maximum response time.
For example, if you set the IGMP query interval to 3 seconds using the
query-interval
seconds, then the IGMP query maximum response time will be automatically
reconfigured to be 2 seconds, so it is less than the IGMP query interval time.
To get the network to converge faster, use the ip igmp
query-max-response-time command and set a low response time value, such as
one or two seconds, so that the clients will respond immediately with a report as a
response to the IGMP Queries.
To set a maximum response time of 8 seconds for vlan20, use the following
Examples
commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the default maximum response time to the default (10 seconds) for vlan10,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
: The IGMP query maximum response time must be less than the IGMP query
Parameter
<response-time>
command, and the current IGMP query interval is less than 3
configure terminal
interface vlan20
configure terminal
interface vlan10
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Response time value in seconds, in the range 1-3180.
ip igmp query-max-response-time 8
no ip igmp query-max-response-time
ip igmp
1565