Keithley 4200-SCS Reference Manual page 1363

Model 4200-SCS Reference Manual
Figure B-13
HP Model 8110A/81110A signal path through a Model 7174A matrix card
Using KCON to add a switch matrix to the system
In order for the Model 4200-SCS to control a switch matrix, the switch matrix must be added to the
system configuration. The switch matrix is added to the test system using the KCON (Keithley
CONfiguration utility).
The switch matrix can be used with a test fixture to test discrete DUT, or with a probe station to test
a wafer. The test fixture or probe station is also added to the system configuration using KCON.
Step 1. Close KITE and open KCON
Close KITE by clicking the close button (X) at the top right-hand corner of the KITE panel. If you
have made changes, you will be prompted to save them. On the windows desktop, double-click
the KCON icon to open KCON.
For details on using KCON, see
Step 2. Add a test fixture or probe station
NOTE:
NOTE:
4200-901-01 Rev. S / May 2017
Keithley CONfiguration Utility (KCON)
Using a switch matrix requires a test fixture or probe station in the system
configuration.
The number of pins defined in the test fixture properties determines the pins that are
available to assign to a switch matrix card column. Make sure the number of pins
assigned is appropriate for your system.
Return to Section Topics
Appendix B: Using Switch Matrices
in Section 7.
B-15