Keithley 4200-SCS Reference Manual page 1462

Appenidx E: Using a Keithley Model 82 C-V System
Hi2n100 k
Hi2n1M
OUTPUTS:
-none-
RETURNED STATUS VALUES:
Returned values are placed in the spread sheet (Sheet tab).
0
-10000
-10001
-10003
-10004
-10020
-10021
-10022
SIMCVsweep82 user module
Overview
This user module uses the Models 590 and 595 to perform simultaneous C-V measurements.
Figure E-37
staircase sweep from -3V to +3V in 20 mV steps as shown in
User-entered parameters and outputs for this user module are explained in the User module
description.
NOTE
E-44
(double) The nominal value of the high range capacitor used to perform cable
compensation for the 2 nF range and 100 kHz frequency. The valid range of
inputs is 1000 e-12 to 2000 e-12 farads.
(double) The nominal value of the high range capacitor used to perform cable
compensation for the 2 nF range and 1 MHz frequency. The valid range of inputs
is 1000 e-12 to 2000 e-12 farads.
OK.
(INVAL_INST_ID) An invalid instrument ID was specified. This generally means
that there is no instrument with the specified ID in your configuration.
(INVAL_PIN_SPEC) An invalid DUT pin number was specified.
(NO_SWITCH_MATRIX) No switch matrix was found.
(NO_MATRIX_CARDS) No matrix cards were found.
(COMP_FILE_ACCESS_ERR) There was an error accessing the cable
compensation file.
(COMP_FILE_NOT_EXIST) The specified compensation file does not exist.
(KI590_NOT_IN_KCON) There is no CMTR defined in your system's
configuration.
shows the default parameters for the SIMCVsweep82 user module. It will perform a
For details on quasistatic measurements, see "Model 82 project plans, Simultaneous C-V
sweep."
Return to Section Topics
Model 4200-SCS Reference Manual
Figure E-22.
4200-901-01 Rev. S / May 2017