Keithley 4200-SCS Reference Manual page 919

Model 4200-SCS Reference Manual
Table 11-38
DualPulseulib UTMs (continued)
User Module
dpulse_load
dpulse_output
dpulse_output_mode
dpulse_period
dpulse_range
dpulse_rise
dpulse_trig
dpulse_trig_polarity
dpulse_vhigh
dpulse_vlow
dpulse_width
dpulse_burst_count
Module Return Type: int
Number of Parameters: 1
Description
Procedure
Table 11-39
Parameter for pulse_burst_count
Name
PulseCount
Table 11-40
Return values for dpulse_burst_count
Value
0
-1
Other
4200-901-01 Rev. S / May 2017
Description
Sets the output impedance of the Dual Card pulse generator.
Turns the output of the Dual Card pulse generator on or off.
Sets the output mode for the Dual Card pulse generator.
Sets the period for the Dual Card pulse generator.
Sets the source range for the Dual Card pulse generator.
Sets the pulse rise time for the Dual Card pulse generator.
Initiates the start of pulse output, and sets the trigger mode.
Sets the trigger polarity of the Dual Card pulse generator.
Sets the high level value for pulse output of the Dual Card pulse generator.
Sets the low level value for pulse output of the Dual Card pulse generator.
Sets the pulse width for the Dual Card pulse generator.
This function sets the burst count for the Dual Card pulse generator. It sets the
number of pulses (periods) that the pulse generator will output when used in the
burst mode.
The parameter and return values for this function are listed in
Table 11-40.
Before using this function, make sure the Dual Card pulse generator has been ini-
tialized using the dpulse_init
to burst.
Description
(long) The burst count for Dual Card pulse generator.
Description
No Errors.
Dual Card pulse generator has not been initialized.
All other error cards match up to LPT errors.
Return to Section Topics
Section 11: Pulse Source-Measure Concepts
function, and use dpulse_trig
Table 11-39 and
to set the trigger mode
11-51