Keithley 4200-SCS Reference Manual page 1674

Appendix N: Additional User Libraries
RGn Command
RXn Command
RnLxxx.x Command Used to set preset #n to temperature xxx.x.
RnSxxx.x Command Used to set program temp. Set point #n to xxx.x.
RnWx.x Command
RnRm Command
RnKm Command
Triotek Send Commands:
All send commands have S as the leading character. All responses for send commands do not
include headers. "S" commands are used with a user provided computer with IEEE for remote
monitoring of the TC controller. Below is a list of send commands and their descriptions:
ST Command
SD Command
SL Command
SM Command
SF Command
SS Command
SW Command
SA Command
SN Command
SH Command
SI Command
N-14
Used to toggle program mode.
n = 0 program halt
n = 1 program restart
Used to enable program mode.
n = 0 program mode disabled
n = 1 program mode enabled
n = 1 to 8
Lower temp limit ≤ xxx.x ≤ upper temp limit
n = 1 to 8
Lower temp limit ≤ xxx.x ≤ upper temp limit
Used to set program window #n to x.x.
n = 1 to 8
0.1 ≤ x.x ≤ 9.9
Used to set program ramp time #n to m seconds.
n = 1 to 8
0 ≤ m ≤ 9999 seconds
Used to set program dwell time #n to m seconds.
n = 1 to 8
0 ≤ m ≤ 9999 seconds
Used to query current chuck temperature.
Used to query current Dewpoint.
Used to query set Dewpoint limit.
Used to query Service Request byte. Refer to Service Request byte for
return format.
Used to query Condition Flag byte. Refer to Condition Flag byte description
for return format.
Used to query local set temperature.
Used to query set window value.
Used to query program start step.
Used to query program cycle count.
Used to query the program status byte.
Used to query program cycle remaining.
Return to Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017