Keithley 4200-SCS Reference Manual page 1576

Appendix J: Using a Manual or Fake Prober
Probesites KITE project example
The following is a step-by-step procedure to properly configure the manual prober so the
probesites Keithley Interactive Test Environment (KITE) project executes successfully. The user
is responsible for the probe station set-up.
Keithley CONfiguration (KCON) utility
NOTE:
Use KCON to add the prober to the configuration.
1. From the Tools menu on the Keithley CONfiguration utility window, click Add External
Instrument > Probe Station
(Figure
Figure J-7
KCON: Adding a prober
2. Select the Manual Prober or the Fake Prober as the model.
Figure J-8
KCON: Selecting a prober
J-6
The following configuration is accomplished using the 4200-SCS computer. Use the
following procedure as a guide to add a prober to the 4200-SCS.
J-8).
Return to
(Figure J-7). The probe station Properties tab appears
Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017