Appendix L: Signatone CM500 Prober
Step 1. Set up communication
The Signatone CM500 prober is configured for GPIB communication only. Make sure the prober
configuration is set up properly for the GPIB communication interface.
1.
Double-click the CM500 icon on the Windows desktop.
Figure L-2
CM500 icon
2.
The prober will initialize the wafer XY stage, theta, and Z chuck.
3.
Set up the GPIB interface.
a. Select the Utility menu and run the Remote Host Interface command.
Figure L-3
CM500 Setup GPIB screen
L-4
Return to
Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017