Configure Trigger Settings - Keithley 4200-SCS Reference Manual

Section 14: KScope (for Models 4200-SCP2 and 4200-SCP2HR)

Configure Trigger settings

Figure 14-2
Figure 14-2
KScope: Configuring the Trigger settings
14-4
explains how to configure the Trigger settings for the scope.
Arm and trigger controls are used to control data acquisition. The arm/trigger
model allows the capture of single or repeating waveforms. The arm controls
are shown in the next illustration.
1. Click Trigger to display the trigger controls.
2. Select a trigger Source and use the enabled input fields to configure the
Trigger A settings. Input fields that do not apply to the selected trigger
source will be locked out or not displayed.
When using Trigger B (ON), a unique trigger Source and Polarity can
be set for it. Keep in mind that the settings for Holdoff, Count, Type,
CHAN1 Level and CHAN2 Level apply to both Trigger A and Trigger B.
3. When the External or a TTL trigger Source is selected, use Trigger Output
to enable and configure it.
Return to Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017