Appendix J: Using a Manual or Fake Prober
Probesubsites KITE project example
The following is a step-by-step procedure to properly configure the Manual Prober so the
probesubsites KITE project executes successfully. The user is responsible for the probe station
setup.
Keithley CONfiguration (KCON) utility
Use KCON to add the prober to the configuration:
NOTE:
1.
From the Tools menu on the Keithley CONfiguration utility window, click Add External
Instrument > Probe Station
(Figure
Figure J-11
KCON: Adding a prober
Figure J-12
KCON: Selecting a prober
2.
Select the Manual Prober or the Fake Prober as the model.
J-8
The following configuration is accomplished using the Model 4200-SCS computer.
J-12).
Return to
(Figure
J-11). The probe station Properties tab appears
Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017