Keithley 4200-SCS Reference Manual page 1664

Appendix N: Additional User Libraries
Syntax:
status =
Figure N-1
CvSweep4294 user module (default parameters)
INPUTS:
InstldStr
Adaptor
StartV
StopV
Number_of_point (int) Number of points in the voltage sweep. Valid range of inputs is 8 to 801
Frequency
Osc_type
Power_Level
Voltage:
Current:
N-4
CvSweep4294(char *Inststr, int Adaptor, double StartV, double StopV, double
Frequency, int Osc_type, double Power_Level, int Model, int Bandwidth,
double V[], int Number_of_point, double C[], int Csize, double G_or_R[],
int G_or_Rsize);
(char *) KCON instrument ID. Default is CMTR1.
(int) Type of cable adapter. Valid input is 1 to 4:
1 Specifies Agilent 16048G (2 pairs of 1-meter coaxial cables).
2 Specifies Agilent 16048H (2 pairs of 2-meter coaxial cables).
3 Specifies Agilent 42942A (7-millimeter 42942A probe).
4 Specifies Agilent 42941A (Advanced impedance probe).
(double) Starting voltage of the sweep. Valid range of inputs is -40 to 40 V.
(double) Ending voltage of the sweep. Valid range of inputs is -40 to 40 V.
points.
(double) Measurement frequency of the sweep. Valid inputs are 20 through
1.1 E+8 Hz.
(int) Type of AC stimulus: 0 = voltage, 1 = current. Default is voltage.
(double) OSC source level:
Valid inputs are 5 E-3 to 1 volt. Minimum step is 1 E-3 volts. Default is 5 E-1
volts.
Valid inputs are 2 E-8 to 2 E-4 amps. Minimum step is 1 E-7 amps. Default is 2
E-8 volts.
Return to Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017