Model 4200-SCS Reference Manual
Figure H-47
KITE: probesubsites project
2.
3.
Running projects
After the wafer is set up and alignment is complete, open the File menu pull-down in the
WaferMap window and:
After saving the project, map, and table, the wafer is ready to probe. Before running the project,
place the prober in Run mode. Also, ensure that the "E" in the WaferMap toolbar is selected
(Figure
Figure H-48
WaferMap toolbar
4200-901-01 Rev. S / May 2017
Select the top node in the ProjectView tab of the Project Navigator window.
Click the green Run button.
•
Select Project and Save
•
Select Map and Save
•
Select Table and Save
H-48).
Return to
Section Topics
Appendix H: Suss MicroTec PA-200 Prober
H-31