Keithley 4200-SCS Reference Manual page 1558

Appendix I: Micromanipulator 8860 Prober
Figure I-34
Set Reference dialog box
probesites KITE project example
The following is a step by step procedure to properly configure the 8860 so the probesites KITE
project executes successfully.
NOTE:
1. Start pcWafer by clicking the pcWfr button located in the pcLaunch window. The pcWfr
window will appear.
Figure I-35
pcWfr button
I-18
The following configuration is accomplished using the pcBridge computer.
Use the pcWafer program to probe a single subsite on multiple dies.
Return to Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017