Table of Contents
Advertisement
Appendix H: Suss MicroTec PA-200 Prober
KCON
NOTE:
Use KCON to add the prober to the configuration:
1.
From the Tools menu (on the Keithley CONfiguration Utility window), click Add External
Instrument > Probe Station
Figure H-34
KCON: Adding a prober
2.
Select the Karl Suss prober as the model
Positioners is correct.
NOTE:
Figure H-35
KCON: Selecting a prober
H-24
The following configuration is accomplished using the Model 4200-SCS computer.
The number of pins defined in the probe station properties determines the pins that
are available to assign to a switch matrix card column. Make sure the number of pins
assigned is appropriate for your system.
Return to
(Figure
H-34). The probe station Properties tab appears.
(Figure
H-35). Ensure that the Number of Pins /
Section Topics
Model 4200-SCS Reference Manual
4200-901-01 Rev. S / May 2017
Advertisement
Chapters
Table of Contents
