Appendix L: Signatone CM500 Prober
Probesites KITE project example
KITE
NOTE:
1.
Open the probesites project example from KITE
a. Select Open Project from the File menu.
b. Open the folder c:\S4200\kiuser\Projects\_Miscellaneous\probesites.
c. Select the project file probesites.kpr.
2.
Set the first parameter of PrInit, which is mode, to 6 (see
Figure L-48
Set PrInit mode parameter
3.
Check the last parameter's value. If the CM500 prober is currently not at its first site, set the
last parameter subprobtype to 1; otherwise set it to 0.
L-24
The following configuration is accomplished using the 4200-SCS. Use KITE to open
and run the probesites project using the new configuration file, which will allow you
to execute the project for this prober.
Return to
(Figure
Section Topics
Model 4200-SCS Reference Manual
G-2).
Figure
L-48).
4200-901-01 Rev. S / May 2017