Keithley 4200-SCS Reference Manual page 1640

Appendix L: Signatone CM500 Prober
Probesubsites KITE project example
The following is a step-by-step procedure to properly configure the KITE project to execute testing
and auto wafer stepping to all programmed subsites successfully.
KITE
NOTE:
To open and run the probesubsites project:
1. Open the probesubsites project example from KITE
a. Select Open Project from the File menu.
b. Open the folder
c. Select the project file probesubsites.kpr.
2. Set the first parameter of PrInit, which is mode, to 6.
Figure L-51
Set PrInit for probesubsites example
L-26
The following configuration is accomplished using the 4200-SCS. Use KITE to open
and run the probesubsites project using the new configuration file, which will allow
you to execute the project for this prober.
c:\S4200\kiuser\Projects\_Miscellaneous\probesubsites.
Return to Section Topics
Model 4200-SCS Reference Manual
(Figure G-2):
4200-901-01 Rev. S / May 2017