Keithley 4200-SCS Reference Manual page 1667

Model 4200-SCS Reference Manual
OUTPUTS:
Z
F
Theta
RETURNED STATUS VALUES:
Returned values are placed in the spread sheet (Sheet tab).
0
-10030
-10090
-10100
-10102
LoadCal4294 user module
User module description
The LoadCal4294 routine performs LOAD calibration for the HP 4294 IMP meter.
shows the default parameters for the LoadCal4294 user module. After LOAD calibration is
performed, it should then be verified by performing an FiSweep on the calibration device.
Syntax:
status = LoadCal4294(char *Inststr, int Adaptor, double LoadRefR, double LoadRefL);
Figure N-3
LoadCal4294 user module (default parameters)
INPUTS:
InstldStr
Adaptor
LoadRefR
LoadRefL
4200-901-01 Rev. S / May 2017
(double *) Array that stores the impedance values.
(double *) Array that stores the frequency points.
(double *) Array that stores theta values.
OK.
HP 4294 not in KCON.
GPIB time-out occurred during communications.
An invalid input parameter is specified.
There is an error when parsing the HP 4294's response.
(char *) KCON instrument ID. Default is CMTR1.
(int) Type of cable adapter. Valid input is 1 to 4:
1 Specifies Agilent 16048G (2 pairs of 1-meter coaxial cables).
2 Specifies Agilent 16048H (2 pairs of 2-meter coaxial cables).
3 Specifies Agilent 42942A (7-millimeter 42942A probe).
4 Specifies Agilent 42941A (Advanced impedance probe).
(double) Reference resistance value of the LOAD.
(double) Reference inductance value of the LOAD.
Return to Section Topics
Appendix N: Additional User Libraries
Figure N-3
N-7