Config: All; Config: Mode - Comtech EF Data CDM-600 Installation And Operation Manual

CDM-600 Satellite Modem
Front Panel Operation
6.3.1.1

CONFIG: ALL

This menu permits the user to configure the unit, in a step-by-step process by viewing
each menu in succession. Use the [←] [→] [↑] and [↓] arrow keys to select and edit the
various parameters. Press ENTER to continue through all the configuration. Press
CLEAR to discontinue.
6.3.1.2

CONFIG: MODE

The MODE is a key parameter when configuring the modem. To simplify the menu
choices, the user must first determine the INTERFACE and FRAMING type for both
Transmit and Receive. Once these have been selected, the user is only presented
with menu choices that are applicable to those particular modes.
IMPORTANT
Examples:
•
•
MODE:
(NONE,IBS,IDR,INSERT,EDMAC,D&I++,ESC++)
Select TX and RX interface type and framing of the unit, using the [←] [→] [↑] [↓]
arrow keys, then press ENTER.
The first parameter is the Interface type. The options are:
•
RS422
•
V.35
•
RS232
•
G703B (balanced)
•
G703U (unbalanced)
•
Audio (FAST option)
•
LVDS
The AUDIO choice permits the user to carry 2 x 32 kbps ADPCM audio as the primary
data. This mode forces IBS or EDMAC as the available framing types.
ALL = START
(STOP, START)
If a G.703 interface is selected, the data rate menu will be restricted to only
the appropriate G.703 rates.
If an IDR framing mode is selected, the data rate choices will be limited to
only those rates specified by IESS-308.
TX=RS422:NONE RX=RS422:NONE
6–7
Revision 7
MN/CDM600.IOM