System Configuration - Mitsubishi Electric GT16 User Manual

62.6 System configuration

The following shows a system configuration example in the case of the microcomputer connection (Ethernet).

System Configuration
The system configuration example illustrated below is explained in this section.

Communication settings on GOT side and monitor screen settings
(1) Transmission settings
Set the transmission settings of the GOT.
The transmission settings in the microcomputer connection (Ethernet) are made at [Detail Setting] on GT
Designer3.
(2) Monitor screen settings
For the monitor screen settings in this system configuration example, refer to the example of the system
configuration of the microcomputer connection (serial).
62.7 Device Range that Can Be Set
For details on the device range of controllers that can be
used on GT16 Handy, refer to the following manuals.
GT Designer3 Version1 Screen Design Manual
(Fundamentals)
GOT1000Series Connection Manual
(Microcomputer, MODBUS Products,
Peripherals) for GT Works3
62.8 Precautions

GOT clock control
The settings of "time adjusting" or "time broadcast"
made on the GOT will be disabled on the PLC.
Use the dedicated commands to set or read out the
clock data of microcomputer.

UDP/IP connection
When the commands are sent from multiple controllers
simultaneously, the GOT may not receive all the commands.
Retry sending the commands on the controller, to
receive them on the GOT again.
62.5.2 Communication detail settings
61.7 System Configuration Examples
62. MICROCOMPUTER CONNECTION (ETHERNET)
IBM-PC/AT-compatible PC
® ®
(Microsoft Visual C++ Ver.6.0)

Station monitoring function
The microcomputer connection (Ethernet) does not
support the station monitoring function.

Interrupt output
The interrupt output is effective only at TCP/IP
connection.
At UDP/IP connection, the interrupt output is not
enabled.
62.6 System configuration
60
61
62
63
64
65
62 - 67