Mitsubishi Electric GT16 User Manual page 1268

*1 Click the [Setting] button and perform the setting in the [GOT
IP address settings] screen.
*2 Select [Yes] only when [Protocol] is [TCP/IP].
*3 The setting value can be changed when the [Existence
check] is [Yes].
62 - 66
62. MICROCOMPUTER CONNECTION (ETHERNET)
62.5 GOT Side Settings
POINT POINT POINT
(1) Special Interrupt Code
The following shows the compatibility between the
special interrupt codes and the event types.
Special
Interrupt Code
(Hex)
*1
Base Screen
Output when the screens are switched according to the
change in the switching device values assigned to 1/2.
*1: Base Screen or Overlap Window 1/2 switches
20H
independently without being interlocked.
(Example of output)
When all the switching device values assigned to
the Base Screen and Overlap Window1/2 are
changed, 3 special interrupt codes are output.
21H Output when Numerical/ASCII Input is completed.
Output when Recipe data transfer (read-out, write-in) is
22H
completed.
Output when Bar code and RFID data have been
23H
imported into GOT
(2) Communication interface setting by the Utility
The communication interface setting can be
changed on the Utility's [Communication setting]
after writing [Communication Settings] of project
data.
For details on the Utility, refer to the following.
12. COMMUNICATION INTERFACE SETTING
(COMMUNICATION SETTING)
(3) Precedence in communication settings
When settings are made by GT Designer3 or the
Utility, the latest setting is effective.
Event type
*1
and Overlap Window