Canopen Slave Control Configuration; Figure 124: Attaching A Canopen Slave; Figure 125: Configuring A Canopen Slave - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
10.3.5

CANopen Slave Control Configuration

An application must be configured in CODESYS before it can access the
connected CAN network.
To add the CANopen slave to the control configuration, right-click "COS
unused[Slot]" and select "Replace element -> CANopen slave".

Figure 124: Attaching a CANopen Slave

Right-click on CANopen Slave and select "Edit" to configure the slave.

Figure 125: Configuring a CANopen Slave

Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
CANopen Master and Slave 321