Figure 122: Adapting Sdos - WAGO I/O SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
750-8208 PFC200 CS 2ETH RS CAN DPM
The value of the objects can be changed. To do this, mark the field in question in
the "Value" column and overwrite the value with your input, then press [Enter].
On initialization of the CAN bus, the set values will be transmitted to the slaves as
SDOs.
An example here is the activation of sending PDOs on a change in analog values,
which is normally deactivated:

Figure 122: Adapting SDOs

Manual
Version 1.1.0, valid from FW Version 02.06.20(09)
CANopen Master and Slave 319