Dhcp Configuration" Page; Dhcp Configuration Xn" Group; Table 87: Wbm "Dhcp Configuration" - "Dhcp Configuration Xn" Group - WAGO I/O SYSTEM 750 Manual

138 Commissioning
7.6.1.29

"DHCP Configuration" Page

The settings for the DHCP service are shown on the "DHCP Configuration" page.

7.6.1.29.1 "DHCP Configuration Xn" Group

Table 87: WBM "DHCP Configuration" – "DHCP Configuration Xn" Group
Parameter
Service active
IP Range
Lease time (sec)
Static hosts/
Static host n
New static host
Click on [Submit] to accept the changes. The changes will be effective
immediately.
Click on [Add] to accept a new assignment. The change is effective immediately.
Click on [Delete] to delete an existing assignment. The change is effective
immediately.
750-8208 PFC200 CS 2ETH RS CAN DPM
Explanation
Enable or disable the DHCP service for the interface
Xn.
Enter here a range of available IP addresses.
Specify the lease time here in seconds. 120 seconds
are entered by default.
This displays the static assignments of MAC IDs to
IP addresses. If no assignment was defined, "No
static hosts configured" is displayed.
Enter here a new static assignment, e.g.,
"01:02:03:04:05:06=192.168.1.20" or
"hostname=192.168.1.20."
You can enter 10 assignments.
Version 1.1.0, valid from FW Version 02.06.20(09)
WAGO-I/O-SYSTEM 750
Manual